Chiller Water Pump P2450 – 24V DC, 50W, 13 L/min

LASER PARTS | WATER COOLING & CHILLERS

P2450 Chiller Water Circulation Pump – 24V DC, 50W

The P2450 is a 24V DC water circulation pump designed for compatible laser water chiller systems. Rated at 50W, with a flow rate of 13 liters per minute and a pressure rating of 18 PSI, this pump helps circulate cooling water through a chiller's internal water circuit.

Maintaining water circulation is an important part of protecting water-cooled CO2 laser tubes from overheating. The P2450 provides a replacement option for compatible chiller systems when an existing pump fails or requires replacement.

This pump is commonly associated with certain S&A CW-5000 and CW-5200 chiller configurations. Compatibility depends on the chiller model, pump specifications, electrical connections, and physical installation requirements.

Key Features

• 50W Rated Power: Electrical power rating identified on the pump housing.
• 24V DC Operation: Designed for use with a compatible 24V direct-current power supply.
• 13 L/min Flow Rate: Manufacturer-labeled water flow specification.
• 18 PSI Pressure Rating: Pressure specification identified on the pump housing.
• Compact Pump Assembly: Features a round housing, water connections, mounting points, and attached electrical leads.
• Chiller Replacement Application: Suitable for replacing a matching P2450 pump in a compatible laser water-cooling system.

Product Specifications

Product Type	Water Circulation Pump
Model Number	P2450
Rated Voltage	24V DC
Rated Power	50W
Rated Flow Rate	13 L/min
Pressure Rating	18 PSI
Electrical Connection	Attached DC Power Leads with Connector
Application	Compatible Laser Water Chiller Systems
Rabbit Laser USA SKU	00068

Performance Note: Flow and pressure specifications are taken from the pump's identification label. Actual water circulation performance depends on tubing, restrictions, system configuration, and operating conditions.

Chiller Compatibility

The P2450 pump is used in certain S&A CW-5000 and CW-5200 water chiller configurations. However, pumps can vary by model revision, electrical connector, mounting arrangement, and cooling-system requirements.

Before ordering, compare the replacement pump with your existing unit, including:

• Existing pump model number
• 24V DC electrical requirements
• Power and flow specifications
• Water inlet and outlet dimensions
• Mounting arrangement and available clearance
• Electrical connector and wiring configuration

Important: Not every CW-5000, CW-5200, or other chiller configuration uses the same pump. Confirm compatibility with your exact chiller model and existing pump before purchasing.

Installation & Safety

• Turn off and disconnect the chiller from electrical power before servicing.
• Drain or isolate the cooling water as needed before removing the existing pump.
• Verify that the replacement pump's voltage, connector, and polarity match the equipment requirements.
• Inspect the water tubing and fittings before reconnecting the cooling system.
• Use clean cooling water appropriate for the chiller manufacturer's requirements.
• Prime and refill the system as required. Do not operate the pump dry unless specifically permitted by the manufacturer.
• Check for leaks, proper circulation, and normal chiller operation before restarting the laser.